2 Posts
0
1186
Powerconnect 7048 stack witch SFP+ module
I have 4 Powerconnect 7048 with SFP+ rear modules and the cables connected as in the official documentation, but I can't stack, always having the message Unassigned.
I did these steps:
en
conf
show switch stack-ports
stack
stack-port Tengigabitethernet X/1/1 stack
stack-port Tengigabitethernet X/1/2 stack
end
copy running-config startup-config
reload
How to make it work?
Thanks
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
1
May 3rd, 2021 08:00
Hi Kardeco,
Unfortunately, stacking is only supported on the CX-4 modules. Page 4 https://dell.to/3ufgqaT So you will need to use different modules from the SFP+ modules. Let us know if you have any additional questions.
DELL-Josh Cr
Moderator
Moderator
•
8.5K Posts
0
May 3rd, 2021 14:00
The part number for the stacking module is RNDV3. The part number for long cables is 10XNR. The part number for short cables is HFT7J.
Kardeco
2 Posts
0
May 3rd, 2021 13:00
Thank you Josh.
Can you tell me the Part# of the CX4 and the cables (I need two short, and two long)?
Thanks