Unsolved
This post is more than 5 years old
2 Posts
0
27872
Powerconnect 7048P Stack 'System Power Status - Error'
I currently have a stack of 4 7048Ps in production working perfectly. Although when entering in 'show system' or 'show system power' in the CLI the Power supplies section currently only gives me the information of the master switch and the other 3 are Status: Error with no information.
1 System Error 0.0 0.0
2 System Error 0.0 0.0
3 System Error 0.0 0.0
4 System OK 4.2 72.4
Entering show switch stack-ports shows all stacking cables working at 16Gb/s.
Any ideas as to how i can get the information of these other 3 switches? as we are just about to roll out VoIP phones to them and I need those statistics.
Thanks.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
September 2nd, 2014 06:00
What firmware are the switches on?
Does the web interface report the same thing? Or does it report correctly?
Thanks
curtis simpson
2 Posts
0
September 2nd, 2014 17:00
Firmware version 5.1.1.7 on the stack.
Web interface reports Health status as '?' for the slaves with no information (all 0.0 watts).
Any ideas what would be causing this?
Thanks
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
September 3rd, 2014 06:00
With the power supplies working just fine, this sounds like it is just a reporting issue. That firmware is an older firmware, the newest firmware includes several improvements on power supply status reporting. I would schedule a time to get the firmware up to date.
www.dell.com/.../DriversDetails
Once updated check the status again.
Thanks