Unsolved
4 Posts
0
342
July 4th, 2022 21:00
Verifying VRRP is working on a VLT setup on Dell EMC force 10
Hi,
How do i verify that the virtual address (VRRP) setup is working from the switches peered with VLT?
There are commands like "show vrrp details" or "show vrrp group-id", however these only shows the VRRP configuration and doesnt show if the VRRP connection is working.
Thank you.
No Events found!
DELL-Erman O
Moderator
•
3K Posts
•
14.9K Points
0
July 5th, 2022 02:00
Hello, please check this article. https://dell.to/3nGuQyS
Verify Configuration
R1#show vrrp
------------------
Vlan 10, IPv4 VRID: 10, Version: 2, Net: 10.10.10.2
VRF: 0 default
State: Primary, Priority: 200, Primary: 10.10.10.2
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 2434, Gratuitous ARP sent: 24
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.10.10.1
Authentication: (none)
R2#show vrrp
------------------
Vlan 10, IPv4 VRID: 10, Version: 2, Net: 10.10.10.3
VRF: 0 default
State: Backup, Priority: 150, Primary: 10.10.10.2
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 2434, Gratuitous ARP sent: 24
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.10.10.1
Authentication: (none)
Hope that helps!