Unsolved
This post is more than 5 years old
6 Posts
0
3671
PowerConnect 2848 - New Switch - 2 VLANs - no DHCP
I'm a bit confused with a 2848, I have it configured as follows:
Ports 1/3/5/7/9/11/13/15/17/19/21/23/25/27/29/31/33/35/37/39/41/43/45/47
Set as members of VLAN1 (Untagged)
Ports 2/4/6/8/10/12/14/16/18/20/22/24/26/28/30/32/34/36/38/40/42/44/46/48
Set as members of VLAN2 (Untagged)
VLAN 1 -> receives DHCP via router attached to port 47 (No issues)
VLAN 2 -> DHCP router attached to port 48 (clients in membership can not pull DHCP address)
I tested a direct link to the router connected to port 48, and was able to pull a DHCP address, so the router side is ok. For some reason the switch is not allowing DHCP traffic on VLAN 2. Is there something I missed in the configuration?