This post is more than 5 years old
19 Posts
0
1194
RIP version on S4048-ON version 9.10(0.1)
Hi
i have some trouble configuring rip on my force10 switch
i would like to go to rip version 2 to be able to have cidr
in the documentation i can read
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive only one or the other version, use the ip rip send version or the ip rip receive version commands in INTERFACE mode.
You can set one RIP version globally on the system using system. This command sets the RIP version for RIP traffic on the interfaces participating in RIP unless the interface was specifically configured for a specific RIP version.
Set the RIP version sent and received on the system. ROUTER RIP mode version {1 | 2]but when i ran in conf mode i can't enter any argument to the router rip commandthen how can i globally activate rip version 2?
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
December 19th, 2017 07:00
I was able to change the RIP version using the version command.
Here is my console output:
S3048-ON>en
S3048-ON#conf
S3048-ON(conf)#router rip
S3048-ON(conf)#router rip
S3048-ON(conf-router_rip)#version ?
<1-2> Version (default = 1)
S3048-ON(conf-router_rip)#version 2
S3048-ON(conf-router_rip)#show config
!
router rip
version 2
Can you share with us your console output where you are running into issue entering the command?
genoscope
19 Posts
0
December 19th, 2017 08:00
in the doc it wasn't clear there was a carriage return.
thanks for the answer