Unsolved
1 Message
0
243
Bios update
I ran SA to update drivers and bios. SA trying to jump from bios version A08 to A29. It has been stuck at 91% installation for about 24 hours now. Is this because it is jumping so many versions all at once? I do not want to stop the install or interrupt it because it can damage the bios. What should I do?
Mary G
4 Operator
4 Operator
•
20.1K Posts
1
December 31st, 2020 09:00
You should not use SA to update bios. It cannot do it. It is just a recommendation that you must investigate, download and install yourself. Go to your download page to check if that is the correct bios for your model. Expand all the info about the update. Remember that an incorrect bios update can brick your computer.
You should have posted your exact model.
redxps630
9 Legend
9 Legend
•
11.8K Posts
0
December 31st, 2020 20:00
Re: Is this because it is jumping so many versions all at once? I do not want to stop the install or interrupt it because it can damage the bios. What should I do?
Jumping over huge gap in bios version is not recommended.
there is nothing you can do other than wait, or bios may get corrupted and cmos bricked.