Unsolved
This post is more than 5 years old
1 Message
0
611
2x Raid 1 on 1 Controller cable
I have a PowerEdge T110 II with Perc S300 Controller. Connected to Controller 1x SSD Harddrive (C drive) and 2x 1Tb Harddrive (D: Drive) configured with Raid 1.
Question:
I want to connect 2x 4Tb harddrives and configure Raid 1 on same controller cable. So then my setup will look like this
1x SSD (C: Drive)
2x 1Tb (D: Drive) Raid 1
2x 4Tb (E: Drive) Raid 1
Will this setup work or do I need to connect harddrives to 2nd Controller cable?
DELL-Chris H
Moderator
Moderator
•
8.8K Posts
0
April 21st, 2016 13:00
ITAcielGeomatics,
Unfortunately the S300 has a hard drive limitation of 2TB, as seen on page 25 of the manual found here. While the S300 can support up to 8 different Virtual Disks, it wouldn't be able to address the 4TB drives in the Raid 1.
Let me know if this helps.