This post is more than 5 years old
2 Posts
0
52411
PowerEdge T100 - SAS 6ir RAID Controller and Fan
Hi Everyone!
We have recently upgraded an old Dell PowerEdge T100 server to support RAID 1 by adding a Dell SAS 6ir PCI-E RAID card. When we boot the server we seeing the message "Alert: Hard disk fan not detected" after the BIOS and POST during boot. We thought this was no big deal until the primary fan started to ramp up to a very annoying speed and volume.
From some preliminary research, I think we need to purchase a Dell FY606 for PowerEdge servers but I am not sure whether we will need some type of mounting bracket or not. Is there anyone that can confirm that part FY606 will fit nicely or do I need to purchase some type of mounting bracket too?
Thanks!
DELL-Rey G
3 Apprentice
3 Apprentice
•
944 Posts
1
March 15th, 2013 11:00
That is the part number I show as well in our internal tools, picture of it below
DELL-Rey G
3 Apprentice
3 Apprentice
•
944 Posts
1
March 15th, 2013 12:00
And because I like to go the extra mile, I found one of these in the lab and here is a picture. Note the location of the connector on the system board, and the fan snaps in to the case in a downward motion.
theMickster7256
2 Posts
0
March 15th, 2013 13:00
Hi Ray,
That looks awesome! I will mark you answer as perfect, but I also have one quick question because you seem to be much smarter with this than me (I am a DBA and SharePoint admin). Do you think that the primary fan on the server is being "ramped up" because the motherboard doesn't see this additional, necessary fan?
Thanks,
Mick
DELL-Rey G
3 Apprentice
3 Apprentice
•
944 Posts
0
March 15th, 2013 13:00
To be honest, I don't know for sure, but that's a logical hypothesis. I have always wondered why this system and the
T105 needed the extra fan, but if they programmed the system to complain about the missing fan, I bet they programmed the fan to speed up as compensation.