RobertSeattle2
2 Bronze

T620 w/ H710P Adapter - Getting MultiBit ECC Errors during high write loads

One of my T620's with H710P adapters has crashed 3 consecutive weekends in a row when it was receiving lots of data (dozens of VHD files) to be written.  The system is Raid-5 with 5 SAS 600GB disks.

I am pretty sure all drivers are up to date.  The system runs fine when under normal loads but has crashed under heavy loads 3 times now which is of obvious concern.  Any suggestions other than contact Dell support and requesting a new adapter?

0 Kudos
1 Reply
Highlighted
Moderator
Moderator

RE: T620 w/ H710P Adapter - Getting MultiBit ECC Errors during high write loads

Hello

What error are you receiving that indicates that the controller is crashing? Where are the multibit errors being reported from and what device are they reported against?

I would suggest that you review information from the system event/hardware log to see what is reported there. Also, if there are errors associated with the controller you should pull and review a controller log.

Thanks

Daniel Mysinger
Dell EMC, Enterprise Engineer

0 Kudos