UNSOLVED
S
smartswitch
1 Message
0
31511
December 8th, 2003 19:00
Poweredge 400SC USB Ports
The documentation for the 400SC says that the USB Ports are 2.0 Using Sandra 2004, it reports all but USB 5 Controller at 1.1. Anyone have an idea as why this is occuring?
USB Controller 1
Model : Dell Computer Corp 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #1
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No
----------------------------------------------------------------------------------------------------------------------------
USB Controller 2
Model : Dell Computer Corp 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #2
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No
---------------------------------------------------------------------------------------------------------------------
USB Controller 3
Model : Dell Computer Corp 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #3
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No
--------------------------------------------------------------------------------------------------------------------------------
USB Controller 4
Model : Dell Computer Corp 82801EB/ER (ICH5/ICH5R) USB UHCI Controller #4
Version : 1.10
Interface : UHCI
Channels : 2
Speed : 48MHz
Supported Speed(s) : Low (1.5Mbps) Full (12Mbps)
Legacy Emulation Enabled : No
-------------------------------------------------------------------------------------------------------------------
USB Controller 5
Model : Dell Computer Corp 82801EB/ER (ICH4/ICH5R) USB EHCI Controller
Version : 2.00
Interface : EHCI
Addressing Support : 32-bit
Legacy Emulation Enabled : No
