I'm seeing some information online that shows that a racadm racreset applies changes, is this true? Seems silly to have to reset the rac to incorporate changes, but just throwing it out there just in case.
Following up, over the weekend I saw some informational messages appear on their own into the remote rsyslog server directory for this server in question. Those being:
Jul 23 03:00:15 server01 Severity: Informational, Category: Storage, MessageID: CTL37, Message: A Patrol Read operation started for Integrated RAID Controller 1. Jul 23 03:51:00 server01 Severity: Informational, Category: Storage, MessageID: CTL38, Message: The Patrol Read operation completed for Integrated RAID Controller 1.
With this said, it appears that events that occur afterconfiguring the remote syslog server. The DIMM errors are not showing up in this log are still prevalent. I'm wondering if clearing the events out of the SEL will allow these DIMM errors to kick in again and then be logged - this is quite frustrating.
BludGeonT
3 Posts
0
July 22nd, 2016 12:00
I'm seeing some information online that shows that a racadm racreset applies changes, is this true? Seems silly to have to reset the rac to incorporate changes, but just throwing it out there just in case.
BludGeonT
3 Posts
0
July 25th, 2016 15:00
Following up, over the weekend I saw some informational messages appear on their own into the remote rsyslog server directory for this server in question. Those being:
Jul 23 03:00:15 server01 Severity: Informational, Category: Storage, MessageID: CTL37, Message: A Patrol Read operation started for Integrated RAID Controller 1.
Jul 23 03:51:00 server01 Severity: Informational, Category: Storage, MessageID: CTL38, Message: The Patrol Read operation completed for Integrated RAID Controller 1.
With this said, it appears that events that occur after configuring the remote syslog server. The DIMM errors are not showing up in this log are still prevalent. I'm wondering if clearing the events out of the SEL will allow these DIMM errors to kick in again and then be logged - this is quite frustrating.
Thanks
mudastix
2 Posts
0
February 8th, 2017 21:00
hello,
1. I need dell server snmp and iDrac snmp configuration/setup.
2. can i use Prtg monitoring tool for above two?
I would be greatly appreciated it if anyone help me.