Unsolved
This post is more than 5 years old
2 Posts
0
34966
August 5th, 2013 12:00
MD3200i Raid Controller Host Port configuration failing
I'm trying to change the IP address of Raid controller module 0, port 0. Every time I try I get "Error 1007 - Could not communicate with the Raid controller module in slot 0 to complete this request.
I was able to change the IP address of the modules management port. I am also able to change the IP address of module 1. Further, I have swapped the two modules and get the same error.
Network cable is plugged in, port shows "connected". Switch shows connection. Baffled.
Anybody?
No Events found!
Dev Mgr
6 Operator
•
9.3K Posts
•
3 Points
0
August 5th, 2013 15:00
If MDSM cannot communicate with one of the controllers it will still let you pull up the unit via the other controller, but certain settings/commands will not work if they go to the controller that MDSM isn't communicating with.
Remove the member from Enterprise Management, and then re-add it, but re-add it manually (not auto discovery) and put in both controllers' IP addresses. After this try changing the settings again on the physical ports.