Skip to main content
Start a Conversation

This post is more than 5 years old

Solved!

Go to Solution

SecurityChris

7 Posts

2500

September 6th, 2018 10:00

Corect R7910 SAS Cable to PERC H730P with backplane 0TGNMY?

I have a rackmount R7910 with an 8-drive bay using backplane 0TGNMY connecting to a Dell PERC H730P RAID controller.  Upgrading from no RAID controller to a cold spare we had, but do not have the cable.  Current cables run from the backplane to the motherboard.  I have seen a few part numbers, but 0F037K seems to be the most common.  I am not sure if any are interchangeable and just have different part numbers on them or not.  Before we drop the money and buy a cable, I would greatly appreciate any input anyone has on which is the correct cable.

Thanks!

DELL-Alasdair R

4 Operator

 • 

754 Posts

September 10th, 2018 09:00

 

Hi SecurityChris,

Yes, you can use either F037K or FN73C to connect your H730P to the backplane.

Thanks

 

SecurityChris

7 Posts

September 11th, 2018 06:00

Thank you. 

PerAnCa

8 Posts

February 13th, 2019 12:00

Hello! But how do you connect the Mini SAS cables to the H730P card? The angled connector of the SAS cable cannot fit into the card, it is too long distance between the connector on the PERC card, I just can't fit it in. Is there any way to bend the connector, that I am not aware of, or how do you fit in in place? This drives me nuts :-). Regards, Per

WUSF Tech

1 Message

April 14th, 2021 13:00

Hi, you ever find an answer to your question? I have an R7910 as well and is fitted with SSDs and I would like to put to good use. Same controller, H730.

Thanks.

View More

View All

No Events found!

Top