3 Posts
0
4218
Precision 3630 Workstation cannot boot after imaging
Hello,
Recently our school purchased Precision 3630 workstations for a CAD lab. I successfully created, captured and deployed a reference image, however when rebooting after imaging there is a message that there are no boot devices. I'm thinking this is because I used legacy boot to PXE to our WDS server. I'm not sure how to get around this short of capturing and deploying the image via Ghost, but that means I would have to do each machine individually. Does anyone have any suggestions?
Thank you - Erin
ewornick
3 Posts
1
February 11th, 2019 08:00
I figured out what the issue was. I did not have the UEFI Network stack enabled in the BIOS. Once I checked that I was able to use WDS as usual. Thanks to all who participated in this discussion!
bradthetechnut
6 Professor
6 Professor
•
8.2K Posts
0
February 5th, 2019 13:00
A couple of articles that may help: Can't Image New Dell
Can't Image New Dell #2
In those articles, one is an Optiplex and another a Precision, but the problem was the same. - The images didn't have the newest NIC drivers.
ewornick
3 Posts
0
February 6th, 2019 09:00
Thank you for your reply, but this does not help. First, both links point to the same article about the Optiplex system. Second, the problem is not the same. I am able to PXE boot to WDS to both capture and deploy successfully. It is after the system is imaged that I am having problems. Once the system reboots to begin sysprep, it says there are no boot devices.
bradthetechnut
6 Professor
6 Professor
•
8.2K Posts
0
February 6th, 2019 18:00
I changed the "#2" link to reflect the intended article. It's more about the problem as the answer wasn't the best. Found a closer related article below:
No Boot Device After Imaging
Sorry my answer didn't work out. Somebody like @bmcowboy might have the better expertise in this case.
bradthetechnut
6 Professor
6 Professor
•
8.2K Posts
0
February 6th, 2019 19:00
In case it helps, I ran across another thread and didn't want to hold back any possibilities.
bmcowboy
573 Posts
0
February 6th, 2019 19:00
Hi all,
Sounds like UEFI/Legacy boot issue after MDT deployment. Check out discussion on this thread in Microsoft Technet Forum with more or less the same problem happened and see if any help.