Unsolved
This post is more than 5 years old
2 Posts
0
63915
2135 Scan to network
Please, can someone help me...Im going around the twist.
I am trying to set up the san to network function on the 2135 (If id read the reviews first, maybe i would have chosen differently. Such a clunky process!)
This is my configuration in
lfeatherby
2 Posts
0
April 21st, 2010 18:00
Sorry, seems what I put in next didnt come out properly.
Here is the configuration I have:
Name Lees Scan
Server Type SMB
Server Address 192.168.etc...
Share Name Scanned Documents
Server Path office.powerfulpoints.com.au\D:\XXXX\Scan Output
Server Port Number 139
JHR_SF
1 Message
0
June 26th, 2013 11:00
did you get this problem sorted in the end?
I am having the same issue and its resisting all solutions thus far.
Jim.
tribalsimba
6 Posts
0
August 28th, 2014 14:00
There was no mention of SMB in the "Fixes and Enhancements".
tribalsimba
6 Posts
0
August 28th, 2014 14:00
However, the original poster has a Server Name, Share Name, Server Path that seems odd to me.
Not sure why in his server path, there is a FQ Hostname, AND a drive letter and colon.
My server destination is:
\\server1\share1\folder1
Which in the Address Book is:
Server name: server1
Share Name: share1
Server Path: folder1
(note: where server1, share1, folder1 are generalized for this forum)
It works fine when the printer is first booted up. and will work for several minutes. However, after about 15 minutes, when it enters "Deep Power Save" mode, when we wake it up, we get 031-530. If we reboot the printer, it works again. Interestingly, when we print to it, when it's in deep power save mode, it does wake up and print, just won't scan until rebooted.
One thing possibly unique, is we have two of these Dell 2665 multifunction printers on our network, and they are both setup with a different TCP/IP hostname, and SMB hostname. RM12665, RM22665 respectively.
Any reflections/suggestions?
DELL-JoeyR
2 Intern
2 Intern
•
259 Posts
0
September 3rd, 2014 09:00
Hello Tribalsimba,
Thank you for posting to the forum. I am hoping you saw some improvements with the sleep issue after the firmware update. Regarding the SMB issue, that is a little tricky to work thru the forum without being able to see the folder and configuration first hand. If you are still having issues please contact us thru either phone or chat support.
Regards,
Joseph E
[tag:iworkfordell]