UNSOLVED

Psynapsx

updated

6 years ago

P

Psynapsx

2 Posts

0

3887

July 25th, 2020 12:00

Enable Wake on LAN on PowerEdge R820

Hello,

I'm trying to enable Wake on Lan on my Dell PowerEdge R820, unsuccessfully so far. I have iDRAC 7 Enterprise. Newest firmware installed. The card is Intel(R) GbE 4P I350-t rNDC. The server runs XenServer. I have no Windows installation.

- I don't see any CTRL-S option when booting. Theoretically I should see one based on the Dell documentation and my settings below but I don't
- I have no link lights activity when the server is shut down (confirms that Wake on Lan is not enabled)

here is what I tried so far:
- in F2 System Setup -> Device Settings -> NIC Port -> NIC Configuration: set "PXE" as Legacy Boot Protocol and enabled "Wake On Lan"

-  in F2 System Setup ->System BIOS -> Integrated Devices: Integrated Network Card 1 is enabled (it was enabled by default though)

- I tried following this guide https://www.dell.com/support/article/hu-hu/sln305365/how-to-setup-wake-on-lan-wol-on-your-dell-system?lang=en

but it's not applicable for R820. For example I don't have "Power Management" menu in BIOS.
According to this documentation, Energy Efficient Ethernet needs to be deactivated. I don't know if it is activated for me or not as there is no such menu in iDRAC 7 or in the BIOS.

Thank you

  • DELL-Joey C

    Moderator

    •

    4170 Posts

    •

    20965 Points

    2551

    0

    Posted July 27th, 2020 00:00

    Hi,

     

    I believe Ctrl-S is for Broadcom network card BIOS access. For Intel, it should be within OS configuration. I don't think poweredge supports wake-on-LAN from total power off, only on standby. Though, R820 is not validation on XenServer. I'm not very verse on XenServer settings on Intel network settings for wake-on-LAN. More over, you have iDRAC Enterprise, you can power on and off the server using iDRAC. 

     

    Let me know if you have questions.

    DELL-Joey C

    Social Media and Communities Professional

    Dell Technologies | Enterprise Support Services

    #IWork4Dell

    Did I answer your query? Please click on ‘Mark as Accepted Answer’ if I did. 

  • Psynapsx

    2 Posts

    2530

    0

    Posted July 27th, 2020 13:00

    Hi,

     

    thank you for your response.

    What is "standby", how can I put it in "standby" state and where can I read more about it?
    Thank you

  • DELL-Joey C

    Moderator

    •

    4170 Posts

    •

    20965 Points

    2513

    0

    Posted July 27th, 2020 19:00

    Hi,

     

    For Windows Server, that would in system hibernation. 

     

    Let me know if you need anything else.

    DELL-Joey C

    Social Media and Communities Professional

    Dell Technologies | Enterprise Support Services

    #IWork4Dell

    Did I answer your query? Please click on ‘Mark as Accepted Answer’ if I did.