FX2 IO Passthrough modules - What SFP+ transceivers are supported in VMWare?

Let me ask again, waht SFP+ Transcievers are supported on the pass through module in an FX2 chassis?

The chassis is populated with 4 FC640 servers.  They have the dual port Broadcom 10 gig cards internal to them.  They will be running VMWare ESXi 6.0 with the latest patches for 6.0.  What brand SFP+ trancievers can I use?

Cisco 850nm mm fiber SFP+ 10 gig?

Generic FS.COM mm fiber 850nb SFP+ 10 gig?

Extreme Networks 850nm mm fiber SFP+ 10 gig?

Brocade 850nm fiber SFP+ 10 gig?

How about Brocade Passive or Active 10gig Twinax cables?

I get most of my stuff from fs.com so let me know if there is a particular SFP+ favorable than another.  Prefer to use multimode OM4 fiber optic cable.

Hi,

Can you private message me a service tag so we can get some additional system information?

http://accessories.us.dell.com/sna/category.aspx?category_id=8334&c=ca&l=en&s=que&cs=caque1&mfgpid=242365&Tab=Parts&stype=2

is there any information for share about this compatibility? i have a problem with this passthrough module with random port failures. I never thought it could be the SFP because it was rpovided by DELL...but...

Hi, thanks for choosing Dell. Yes I looked into it as well didn’t see any information table on it. Personally I don’t think it would be too much of a problem since it’s Passthrough (bypass) but again, there’s no official information on it please know that.