5 Posts
0
1966
R740XD fan speed at 100% when connecting the 4x 2,5" backplane
Hi all,
The rear backplane on my 14th gen R740XD (iDRAC9) is causing the fans to run at 100% constantly. Does not matter if it's occupied with disks or not.
As soon as I disconnect the rear backplane and start the server again, the fans run at normal speed.
I've been searching online, but can't seem to find users with a similar issue. Any ideas? Any additional info I should provide?
BIOS version: 2.14.2
iDRAC firmware version: 6.00.00.00
Thanks in advance!
PJ
DELL-Shine K
4 Operator
4 Operator
•
3K Posts
0
July 18th, 2022 08:00
Can you check whether you have a Standard or High Performance Fan? R740xd with rear backplane need high performance FAN. You can refer below link for FAN requirement for various configuration
https://www.dell.com/support/manuals/en-us/poweredge-r740xd/per740xd_techspecs_pub/thermal-restrictions?guid=guid-d7f5958d-1465-42f7-bab0-7d352f3f5291&lang=en-us
PJVH
5 Posts
0
July 18th, 2022 09:00
Bingo, I think you're on to something here. It's a refurbished system and they shipped it with the standard performance fans. I'll see if I can get the performance fans and if that fixes the issue.
Thank you for your help!
PJVH
5 Posts
0
July 18th, 2022 01:00
Hi, thanks for taking the time to respond.
Looks like 6.00.00.00 was released but immediately taken offline again. I had already reverted to 5.10.30.00 but the issue remains.
DELL-Marco B
Moderator
Moderator
•
3.5K Posts
0
July 18th, 2022 01:00
Hello,
where did you get this idrac version?
I see in our site the last iDRAC version is this 5.10.30.00:
https://dell.to/3PDLURZ
Please can you install this version?
Thanks
Marco
DELL-Marco B
Moderator
Moderator
•
3.5K Posts
0
July 18th, 2022 05:00
Where do you see that fan are at 100% ? Because it is normal that fans increase speed when rear backplane is installed.
Can you check also PERC firmware?
Thanks
Marco
PJVH
5 Posts
0
July 18th, 2022 10:00
Hi Marco,
All firmware is updated to the latest version. PERC is at 51.16.0-4076.
Fan speeds with (empty) rear backplane attached:
I can't set the minimum fan speed to lower as 100 either:
Fan speeds without (empty) rear backplane attached:
I think the solution will be what Shine K suggested. Thanks a lot guys.
PJVH
5 Posts
1
August 1st, 2022 02:00