Unsolved
This post is more than 5 years old
31 Posts
0
1951
How to configure IDrac on Recover Point RPA?
Hi,
I'm try to configure the Idrac on RPA from his Bios , but every time that I gave him an IP address it changes my ETH0 address(I know that they share the same interface) is there a normal procedure of how to configure it?
etaljic81
1K Posts
0
March 5th, 2012 05:00
Did you follow these steps?
jlarchev_samse
18 Posts
0
July 30th, 2014 00:00
Hi,
I'm trying to configure Idrac on my RPA's but I can't see "(7) IDRAC Support" in the "advanced options" menu
Why ?
forshr
1.1K Posts
0
July 31st, 2014 06:00
It's probably because they are Gen5 RPA's and use BMC?
Regards,
Rich Forshaw
Consultant Corporate Systems Engineer - RecoverPoint & VPLEX (EMEA)
Data Protection & Availability Division