This post is more than 5 years old
5 Posts
0
5377
esrs add manage device
Hello,
I had recently install the esrs virtual appliance on our infrastructure.
i have a question for the way that i will add our VNX 5100.
The VNX has two SP's with one IP each. When i'm going to add it next to serial number i have some choice's and i don't know was i have to choose. The choice's is BLOKCKA, BLOCKB, FILEP, FILES, FILEA, CS0,CS1.
If someone can give an advice i will be obligated.
Thank you!
gallom1
22 Posts
0
October 20th, 2016 03:00
Hello,
here a VNX legend:
BLOCKA = SPa IP address
BLOCKB = SPb IP address
in the case of VNX Unified there are also:
FILEP = Primary Control Station IP address
FILES = Secondary Control Station IP address
FILEA = is used if is configured an IP alias for the primary and secondary Control Station
CS0 and CS1 are absolete
Regards
Marco
apostolos_artem
5 Posts
0
October 20th, 2016 06:00
Hello,
That was exactly what i need.
I just make the configuration needed and contact the support for approving my request.
Thank you!
apostolos_artem
5 Posts
0
October 24th, 2016 04:00
i have contact with emc for approving my request some days now through a open ticket for esrs installation but nobody had answer me.
Do you know if i had to contact someone specific?
apostolos_artem
5 Posts
0
October 24th, 2016 06:00
Service Request Number
05147754
Regards
gallom1
22 Posts
0
October 24th, 2016 06:00
Could you give the ticket number please?
Regards
Marco
apostolos_artem
5 Posts
0
October 24th, 2016 08:00
Hello,
Thank you very much for your assistance!
I try to start a chat but it was unavailable. i will try again later.
If i can't contact either with chat i will request to close the open SR.
I see the GUI of my ESRS and everything was good as you said.
Thank you again!
Regards!
Apostolos
gallom1
22 Posts
0
October 24th, 2016 08:00
The Service Request was stuck. However the use of Service Request for this activity is correct, alternatively you can open a chat at support.emc.com portal.
In the mean time I have approved the two deploy request and now all looks good.
Regards
Marco