ECC and cisco 9216i

Question

Hello,

we have cisco 9216i switches in our fabrics (for write acceleration features)
but ECC seems not to be able to apply zoning correctly in theses switches.
We need to use cisco tools for zoning and then import active zone set to ECC.
Does a workaround using ECC exist ?
Will it be corrected in a future revision of ECC ?

Thank you
Fox

michaelf1 · Answer

Consult the ControlCenter Support Matrix matching the version of ControlCenter you run. If the Cisco 9216i's are not listed in this, then the configuration is currently unsupported in that release.

As to them being supported in future. You should ideally consult with your Account Manager and see if they can confirm if anything is in the pipeline for supporting them.

fox2_b90627 · Answer

Well, I think I need to apply SP5 patch (I'm running 5.2 SP4)Theses switches are in SP5 Support Matrix.Thank you very much for your helpFox

michaelf1 · Answer

Well, I think I need to apply SP5 patch (I'm running5.2 SP4)Theses switches are in SP5 Support Matrix.Thank you very much for your help Excellent.Glad to help.Message was edited by: michaelf

fox2_b90627 · Answer

Humm, I did check in support matrix for ECC 5.2 SP4, and these switches are supported ....I think a case is needed.Thanx a lot

GlenH · Answer

Hi Fox,ECC does not discover or support the FCIP ports - do the VSAN's you're discovering use them as ISL's in the fabric ?It also does not support interop vsan's.Do either of those apply to you ?Glen.

fox2_b90627 · Answer

Hi Glen,In fact cisco switches are well discovered but the issue is when we are trying to add new zones on VSAN. The only way to have a consistent zone set is to apply it using cisco GUI and then to import it under ECC.Fox

Storage Resource Management (SRM Suite)

ECC and cisco 9216i

Was this post helpful?