This post is more than 5 years old
24 Posts
0
875
Solutions Enabler upgrade - have command paths changed?
I just upgraded Solutions Enabler from 6.0 to 6.4.3 (as part of a ControlCenter upgrade). Before I push the upgrade out to the hosts, how can I quickly tell what commands have changed or command paths have changed between these versions? I am concerned that I might be breaking some scripts when I do this...
seamuscoffey
472 Posts
0
September 13th, 2008 02:00
A 'push' upgrade of Solutions Enabler from ControlCenter Console should not affect any existing scripts. The Release Notes of both SE versions would be a good starting point in terms of checking what commands/paths etc have changed.
Regards,
Séamus Coffey
EMC Global Services
SKT2
1.3K Posts
1
September 14th, 2008 17:00
Have a look here too
https://forums.emc.com/forums/thread.jspa?threadID=87571&tstart=0
seamuscoffey
472 Posts
0
September 23rd, 2008 00:00
Do you need more information or can the thread now be marked as answered?
Thanks,
Séamus Coffey
EMC Global Services