Unsolved
This post is more than 5 years old
25 Posts
0
2200
Cannot create a symclone create session
Hello,
While running the symclone command, i am receiving the below error :
# symclone create -tgt precopy
Execute 'Create' operation for device 'precopy'
in device group 'sumitdg' (y/ ) ? y
'Create' operation execution is in progress for device 'precopy' in
device group 'sumitdg'. Please wait...
Could not select requested device(s) from the specified device group
Below is the symld output :
# symld list
Device Group (DG) Name: sumitdg
DG's Type : REGULAR
DG's Symmetrix ID : 000192604026
Standard Device Name Directors Device
---------------------------------- ------------- ----------------------------
Cap
Logical Physical Sym SA DA :IT Config Att Sts (MB)
---------------------------------- ------------- ----------------------------
DEV001 rhdiskpower21 083C 09E:0 07A:D7 2-Way Mir RW 5121
DEV002 rhdiskpower22 083D 09E:0 10B:C2 2-Way Mir RW 5121
TGT Devices associated with this dg:
TGT Device Source Device Status
----------------------------------- ---------------------------- -------------
Logical Sym Att. Sts Logical Sym SRC <=> TGT
----------------------------------- ---------------------------- -------------
TGT001 074B (M) - RW TGT001 074B Created
Legend for TGT devices:
(+): TGT is paired with a member device.
(-): TGT is paired with a non-member device.
Can anyone please help out on what could be the issue. Does the '-' flag in the symld output causing the problem ?
Sumit
Stephanie_P
180 Posts
0
July 30th, 2012 05:00
Hello,
The team is going to move this post to the Support Forums community where your question can be addressed.
Thanks,
Stephanie
Mabro1
666 Posts
0
July 31st, 2012 06:00
This question has been moved to the Symmetrix Support Forum. This will ensure your question gets to the right audience.
Regards,
Mark
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
July 31st, 2012 06:00
aren't you specifying the wrong device group ? Should't it be "sumitdg"
sumit_ghosh
25 Posts
0
July 31st, 2012 10:00
i am using the 'sumitdg' only
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
July 31st, 2012 11:00
why did you not specify it in your symclone command ?
sumit_ghosh
25 Posts
0
July 31st, 2012 23:00
Helo,
If my source device are normal devices, but target devs are showing RDF1_OR_RDF2_Capable, will it cause any kind of issue?
sauravrohilla
859 Posts
0
July 31st, 2012 23:00
No, its not going to cause any problem. Something is not right in your setup. Can you please post the symsg show sumitdg output?
regards,
Saurabh
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
August 1st, 2012 04:00
symdg ?
sauravrohilla
859 Posts
0
August 1st, 2012 04:00
ooops, yeah symdg show sumitdg
thanks dynamox