This post is more than 5 years old
4 Posts
0
714
HotSpare drive replacement fails
Hi all,
I have problem to replace bad HS disk drives on DMX3 with Enginuity 577.105.94. Procedure stops on step 19 with message "Drive failed to initialize". If I repeat the procedure with another new disk drive, the result is the same and also doesn't matter at which position is the bad HS disk, it fails always. The Enginuity is the same for long time, some months ago the Procedure ran well.
Please, is this problem known to someone?
Kleanthis76
26 Posts
0
January 16th, 2013 11:00
Hi Velitel,
Please check emc243335. I think this is your issue.
Regards,
Kl.
Velitel
4 Posts
0
January 17th, 2013 01:00
Hi Kleanthis,
thank you very much, I hope this helps. Will update later.
BR
Ivan
Zikas
278 Posts
0
January 17th, 2013 01:00
Hi Velitel,
the option to have "Drive failed to Initialize" is when:
the disk is DOA
the disk is smaller than the one you are going to change
the disk has different Bits Per Sec BPS
the disk is different technology
the disk has not the same P/N
If you are going to use a bigger disk than the one is used, you are going to be asked if you want to continue.
Hope that i helped you