This post is more than 5 years old
2 Intern
•
360 Posts
0
1326
How to use "Open Replicator" to replicate data incremental?
Dear All,
How to use "Open Replicator" to replicate data incremental?
I used below command to create the replication.
" symrcopy create -name ORTest -copy -push -hot -differential -f ORTest.txt ".
The " ORtest.txt " content :
#Source_device_id Target_device_id
symdev=0917:07A0 symdev=1321:021A
I used below commnad to enable the replication and ran it successfully.
" symrcopy -session_name ORTest activate -noprom "
I tried to use below command to replicate data incremental.
" symrcopy -session_name ORTEST recreate "
" symrcopy -session_name ORTest activate -noprom "
It can run it successfully, but the time cosuming is the same as first replication.
Are above commands correct?
Thank you for any help.
Dennis
sarpydog
2 Intern
2 Intern
•
360 Posts
0
December 27th, 2012 21:00
I can set the "pace" to increase the speed.
Thank you for input.
Dennis
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
December 5th, 2012 03:00
that looks good, not a chance that you just have that much activity ?