Unsolved
This post is more than 5 years old
10 Posts
0
5114
Discovery problem
I am trying to monitor a server that passes SNMP tests under tools, but when I do a discover or inventory the IT Assistant applciation does not see it -- or it does not show up under devices and I can't get any information. There are no error messages.
I don't understand why it would pass the SNMP diagnostic tests but otherwise not work.
Any suggestions? Thanks.
ePatrick
116 Posts
0
October 11th, 2005 12:00
shaboyi
10 Posts
0
October 12th, 2005 01:00
OpenManage Server Administrator is installed on the target machine and everything looks good. All the tabs open properly and nothing unusual reported. In otherwords, it installed correctly. I double checked the SNMP service settings and they are OK -- the test itself says so (ie, the Get and Set commands pass the test).
So I can't figure it out. I used the same setup on another machine and it worked fine. The settings are identical.
Thanks for the reply and any other suggestions. Charles