Unsolved
15 Posts
0
3802
How to configure call Home in Unity All Flash / 450F with Centralized ESRS gateway server
How to configure call Home in Unity All Flash / 450F with Centralized ESRS gateway server
Unsolved
15 Posts
0
3802
How to configure call Home in Unity All Flash / 450F with Centralized ESRS gateway server
Top
kelleg
4.5K Posts
0
November 5th, 2018 12:00
Go to the Unity Hub,.
https://community.emc.com/docs/DOC-51784
then to the All Flash Hub
https://community.emc.com/docs/DOC-51785
Then under the Plan and install section, select the ESRS item
glen
SteveK821
2 Intern
2 Intern
•
141 Posts
0
November 9th, 2018 06:00
The guide is here:
https://www.emc.com/collateral/TechnicalDocument/docu69327.pdf
You just need to configure the ESRS Gateway IP on your Unity. Afterwards you can check in your ESRS Gateway if the Unity system appears under Managed Devices.
There are no templates to configure, if I remember correctly. Not like the VNX.
stupo
15 Posts
0
November 10th, 2018 02:00
Thank you Stephen
I was told that we need to get the Software ID - SWID of the Unity array and this Software ID needs to be supplied in ESRS Registration step to complete the registration. If this ID is not given then call home doesnot work. Is this true ?
Any idea on this please ?
SteveK821
2 Intern
2 Intern
•
141 Posts
0
November 11th, 2018 23:00
I've never been asked for a Software ID for the Unities I have installed. With Integrated ESRS it sends you a code by email, and you need to enter this during the setup. For a hardware-based unity (not VSA) then it's the Hardware Serial Number, which is on the PSNT Tag on the Controller Shelf (DPE). This should already be listed in support for your Site ID under
https://onlinesupport.emc.com/CompanyAdminSites
I think you might need this when you enter the device in your centralized ESRS gateway (if the Unisphere Wizard does not enter it automatically)
AndreD Dell
Moderator
Moderator
•
239 Posts
0
November 12th, 2018 00:00
This is not true stupo
The entire config for SRS on a Unity system is done from the Unity GUI.
I would recommend that you go through the Unity documentation carefully. I am reading other posts from you and you are comparing Unity to VNX a lot, which you should not be doing otherwise you will end up with problems / misconfigured device.
The SRS docs contain all the requirements and how to's.
Thanks
Andre @ Dell EMC