Unsolved
This post is more than 5 years old
2 Intern
•
220 Posts
1
2282
SYMCLI Remote Mode Execution
Hi
I setup a remote mode (SYMAPI thin client) on a server to run the Symcli commands. I set following environment variables to run the SYMCLI Commands
SYMCLI_CONNECT_TYPE=REMOTE:
SYMCLI_CONNECT=SERVER1
While executing Symaccess command on the Solution Enabler(7.5) server I get all the Lun mapping data. But when I run the same command on the remote server , I get only the partial data compared the output I got from the main server(Solution Enabler server).
So I have to do anything(any setup I have to make) on the remote server(SYMAPI thin client server) to get the full Lun mapping data.
Thanks
Naren
Roshan_Raju
53 Posts
0
May 7th, 2013 06:00
Hi Naren,
Could you confirm what the client version of SE is? Also paste the command output you are referring as incomplete for reference?
Thanks!
Regards,
Roshan Raju.
sauravrohilla
859 Posts
0
May 7th, 2013 07:00
Naren, are you taking the output in XML format?
regards,
saurabh