Connect single host to VNX via iscsi , and to CX3 VIA FC

you don't see the iSCSI LUNs when you run "powermt display dev=all" ? Tried "powermt config" ?

yes sir

when i make powermt display dev=all i can see just FC Disks

i tried powermt config/powermt check , same result

by using fdisk -l i can see all ISCSI and FC disks via all paths

BR

thanks all but

From EMC Host Connectivity Guide for Linux, rev A32, page 121:

"A single host cannot mix HBAs and NICs to connect to the same
array or different arrays.
A single host cannot attach to a Fibre Array and ISCSI Array at the
same time."

So, as its states, this cannot be done.

There you go! you found the answer yourself. Please mark your own answer as the correct one!

Huh.. why cant we Connect to different arrays using different protocol  ?

I really don't know, but he did find it in the host conn guide. I've never encountered such an environment anyway, so I'd have to go with the manual here.

And I did verify in the pdf from the EMC site: it does indeed say so!

https://support.emc.com/docu5128_EMC-Host-Connectivity-Guide-for-Linux.pdf?language=en_US

i think the problem related to PowerPath ,

becaus i connect TO two differnt arrray (ISCSI,FC) and i can see all paths ,

but powerpath can handly only FC paths and Ignore ISCSI paths..

so i can acces ISCSI paths without Powerpath