Unsolved
This post is more than 5 years old
6 Posts
0
959
Problem to add host ucs blade on vnx5300
Hello,
The zoning is done and is ok .
show zone active :
But on vnx 5300 the Initiators from UCS aren't not listing.
I try create the initiators but they are not "logged In" :
Any help appreciated
regards,
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
April 23rd, 2015 08:00
booting form SAN ? Zonned to correct VNX (sorry but have to ask )
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
April 23rd, 2015 08:00
also how many initiators are already logged-in to this VNX ?
tesis974
6 Posts
0
April 24th, 2015 00:00
Yes the zonning is correct :
On the switch , I can see the link UP usc blade :
others ideas ?
tesis974
6 Posts
0
April 24th, 2015 00:00
Hi Dynamox,
Actually there is 35 initiators actually : 30 are "logged In" and 5 are "Not logged" .
What is the limit number of initiator ?
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
April 24th, 2015 04:00
can you boot from a ubuntu live-cd and see if it logs-in.
tesis974
6 Posts
0
April 24th, 2015 04:00
Hi Dynamox,
I tried to reboot Hyper-V server ,it still does not show up as logged-in .
During installation of Hyper V , the server not detect any LUN.
if I delete manually added initiators, initiators are not listed.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
April 24th, 2015 04:00
256 per port ..so that's not it. Hmm. So after you manually register the host and then try to reboot Hyper-V physical ..it still does not show up as logged-in ?
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
April 24th, 2015 05:00
and for good measure restart management server on each SP (http://SPA/setup)