Unsolved
This post is more than 5 years old
7 Posts
0
982
Shutdown VNX (Unified)
Hi all,
I to do a shutdown of an VNX (Unified, V.2). I used the procedures provided by SolveDesktop but I am wondering about one point - when i had run the commands for setting the controlstation/datamovers to haltet state the storage processors got unresponsive after completion. i assume now that when shutting down the CS will also shutdown the SPs of the array.
is this a special behavior for unified systems, cause as i remember for block only it was just trigger the SPS powerswitches.
did i missed something ?
is this normal behavior ?
could not figure that out from provided SolveDesktop document.
thanks and regards
s_15
7 Posts
0
December 15th, 2014 02:00
Meanwhile i could figure out what happend and this is normal behavior so i'll close this thread.