Unsolved
This post is more than 5 years old
35 Posts
0
608
Tell me How to configure SAN Copy from Block to Unified, plz!
Hi again.
I'm planning to configure some SAN Copy iscsi sessions from Block to Unified VNX.
I won't use Mirror View.
Has anyone experienced such configuration?
And is there any special procedure, differying from Block-to-Block iscsi SAN copies?
Sincerely,
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
October 18th, 2013 07:00
should be no different, as long as source ports can talk to target port you are good to go.
leiraska
35 Posts
0
October 20th, 2013 17:00
thans to such a quick reply!
may ask you one more question?
Should I separate the iSCSI port for SAN Copy from that for Mirror View even if i'm not using MV.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
October 20th, 2013 18:00
from what i remember reading it was recommended to separate MirrorView and SanCopy traffic regardless if MirrorView was used or not.
Madhug1
127 Posts
0
October 21st, 2013 10:00
Hi,
You may refer this document for more information.
http://www.emc.com/collateral/hardware/white-papers/h8248-migrating-block-vnx-wp.pdf
Thanks
Madhusudan