Unsolved
This post is more than 5 years old
19 Posts
0
5466
Temperature Monitoring VNX Systems
Hey all,
does anyone know a way to get the Temperature Sensor Data from the System Monitored? within the GUI Monitoring i cant find something, is there any CLI Command or something?
regards,
Martin
mwidemann
19 Posts
0
August 6th, 2012 02:00
Yes this will do most of my usecase, now i only must find a way to get CPU Temperature and so on. Because with that Command i only get back the Inline Temperature of the Chassis. If you have some Advanced Commands, please let me know.
Maybe there is a way to get the Info via SNMP or so...
rupal1
433 Posts
1
August 6th, 2012 02:00
I think you are looking for the power consumption figures for your array and you can get the same by using the below commands.
For Block Only
The command line to determine the power consumption and reports inlet air temperature and input power:
naviseccli -h <IP address of SP A/B> environment -list -array [-power] [-present]|[-average] -enclosure [bus_enc|spe] [-power|-intemp [f|c]] [-present]|[-average] -sps [-sp a|b] [-power] [-present]|[-average] -all
For File/Unified
The nas_environment command is as follows :
nas_environment -info { -system [-present|-average] -dme [enclosure_id] [-intemp [f|c]|-power] [-present]|[-average] -array [-present|-average] -shelf {<shelf_id>|<-all>} [-intemp [f|c]|-power] -present|-average] -battery [a|b] [-present|-average] -spe [-intemp [f|c]|-power] [-present|-average] -all }
For GUI Monitoring please Refer Primus id : emc287025 for further explainations and procedure.
Its a Customer veiwable article.
Thanks
Rupal Rajwar
rupal1
433 Posts
0
August 6th, 2012 03:00
May i know the model of the array.
Thanks
Rupal Rajwar
mwidemann
19 Posts
0
August 6th, 2012 04:00
Hi,
i need to know that for VNX Systems (all of them). I test this on out Lab System, which is a VNX5300.
Martin
rupal1
433 Posts
0
August 6th, 2012 05:00
No there are no advance commands to know the CPU temp (in specific) even in VNX. Through SNMP also i dont think you can get this info as its not even mentioned in the V3 documents.
Thanks