Unsolved
This post is more than 5 years old
7 Posts
0
1041
powerpath failover time
I have the environment of VNX7500 and ESXi5 which powerpath/VE(5.7) is installed.
When I have tried one FC cable on ESX to unplug, queuing time was very shoter.(more than powerpath (linux and windows and so on))
So, after queuing time is 10s, IO re-started.
Is it correct that powerpath/VE failover time is very short ?
(powerpath/VE detect immediately that fabric was changed ?)
AnkitMehta
1.4K Posts
0
July 14th, 2012 10:00
Welcome to EMC Community Network!
I believe this question would be answered best by ECN Contributors and Experts from the https://community.emc.com/community/support/family/vnx
The community moderators and managers have been notified, this discussion will be move to https://community.emc.com/community/support/family/vnx.
Thank You
rupal1
433 Posts
0
November 9th, 2012 00:00
To some extent yes, It depends on the 3 factors Automate failover and recovery , Optimize load balancing, Standardize path management.
So i think this answers all.
Thanks