Unsolved
This post is more than 5 years old
2 Posts
0
11750
Help!! cant reimage S90 clients
Help!! cant reimage S90 clients
hello all
this is my first bash at reimaging S90's
i have set up an old 2000 server, installed DHCP an IIS.
Connected server to switch an S90 to switch
installed simple imager an installed the correct image from the wyse site
power on S90
it connects to server an i see the log on the server screen but within a min or so i see an error
the thin client then reboots an it starts over
anyone any ideas?
thanks
aleena-2015
1 Message
0
July 8th, 2015 01:00
yes , kindly post the solution
If hankering after pass4-sure.net preparation wikipedia program to hit success on first try plus gain additional knowledge for next Stanford University . if you needIBM good luck
Rmontalvo1
623 Posts
0
July 8th, 2015 01:00
Try using a dumb hub instead of a switch.
Roger Montalvo
Visit our Dell Wyse Thin Client Knowledge Base and Manuals web site at www.wyse.com/KB
Visit our Dell Wyse PocketCloud Knowledge Base and Manuals web site at http://pocketcloudsupport.wyse.com/forums
[SIGPIC][/SIGPIC]
RustyMonkey
96 Posts
0
July 8th, 2015 01:00
Review the WSI guide and make sure you don't skip or change a step. Both WSI and the S90 have been discontinued for several years, so you may not be able to get much help.
mudcow007
2 Posts
0
July 8th, 2015 01:00
just another note the part number of my clients is
902115 - 02L
if that helps at all
digitad
1 Message
0
July 8th, 2015 01:00
I get the same results as you only that I have P/N: 902099-05
Please update thread when you find any solution.
best regards
naitik1
10 Posts
0
July 8th, 2015 02:00
So anyone with the solution..?
bryguy21
48 Posts
0
July 8th, 2015 02:00
it took me forever to get this working. Make sure the firewall on the winterm is disabled. You have to hold down shift, enter the default login Administrator/Administrator. In this mode you can also disable the write protect filter (click on red icon). At this point go to control panel > settings. You'll be able to go into the firewall. Disable it.