Unsolved
This post is more than 5 years old
8 Posts
0
1065
Mapping powerpath storage interface # to XtremIO FC port
When viewing XIO connections in PowerPath, how can I determine which XIO port is being referenced.
Example below, how do I map Interface 41, 11, 62, to the actual FC ports on the array?
Pseudo name=harddisk25
XtremIO ID=APM00144623846
Logical device ID=514F0C5359800083 [T_Data.snapshot.1461449014]
state=alive; policy=ADaptive; queued-IOs=0
==============================================================================
--------------- Host --------------- - Stor - -- I/O Path -- -- Stats ---
### HW Path I/O Paths Interf. Mode State Q-IOs Errors
==============================================================================
4 port4\path0\tgt7\lun15 c4t7d15 41 active dead 0 0
5 port5\path0\tgt7\lun15 c5t7d15 11 active dead 0 0
5 port5\path0\tgt9\lun15 c5t9d15 62 active dead 0 0
6 port6\path0\tgt8\lun15 c6t8d15 41 active alive 0 0
6 port6\path0\tgt6\lun15 c6t6d15 21 active alive 0 0
6 port6\path0\tgt5\lun15 c6t5d15 61 active alive 0 0
6 port6\path0\tgt4\lun15 c6t4d15 52 active alive 0 0
6 port6\path0\tgt3\lun15 c6t3d15 32 active alive 0 0
6 port6\path0\tgt2\lun15 c6t2d15 72 active alive 0 0
6 port6\path0\tgt1\lun15 c6t1d15 12 active alive 0 0
6 port6\path0\tgt0\lun15 c6t0d15 01 active alive 0 0
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
1
May 19th, 2016 22:00
This seems to be an older version of PowerPath.
6.0 or later will show the friendly port names.
There are 4 (possible) targets ports per node (2 fc, 2 iscsi).
The port number is: (node_index -1)*10 + (1,2,5,6) (where 1,2 are the fc targets, 5,6 are the iscsi).
For example, node1 targets will be (1,2,5,6). Node2 targets will be (0xb, 0xc, 0xf, 0x10) and so on.