I ran a splitter off the front fan having the 4 pin connect to the primary front fan and the 3 pin to the new secondary fan.The secondary fan isn’t working, but the primary fan is running around 12%. When I first plugged it in, it turned on but then turned right off. Tried unplugging/plugging in a few times and it did the same thing. The new fan is a CORSAIR AF ELITE Series, AF120 ELITE, 120mm. Anyone know why it wouldn't be running at the same speed as the primary since that has the 4 pin connection? Any help would be greatly appreciated!
I don't think the Slave fan runs at the same rpm as the Master fan connected to the 4-pin side of the Y-splitter, but at the same percentage of its top rpm. So if your OEM Dell fan is running at 12%, that would be 0.12 x 1850 rpm for the Corsair Slave fan, or 222 rpm, which is below the 400 rpm minimum.
Push up your fan curve so the Corsair gets its minimum voltage to run.
It's not recommended to Y-split 2 fans with a different RPM, since you end up not being able to match the fan speeds ever.
The OEM fan is around 4,000 RPM, the Corsair fan 1,850 RPM. The Corsair fan needs a minimum of 400 RPM signal to run, so you have to make sure the OEM fan is set at at least 800 RPM. I would suggest 1,000 for speed setting in AWCC on the front fan.
ProfessorW00d
6 Operator
•
2378 Posts
•
10262 Points
270
0
Posted October 20th, 2022 13:00
I don't think the Slave fan runs at the same rpm as the Master fan connected to the 4-pin side of the Y-splitter, but at the same percentage of its top rpm. So if your OEM Dell fan is running at 12%, that would be 0.12 x 1850 rpm for the Corsair Slave fan, or 222 rpm, which is below the 400 rpm minimum.
Push up your fan curve so the Corsair gets its minimum voltage to run.