All storage on one data mover has to be either mirrored or not

If you get another data mover (VG8 supports up to eight) you can set that up as “unprotected” and use that for file systems that aren’t mirrored (on extra LUNs).

For the second question I don’t know what you mean.

Hi Rainer,

Thanks for responding.

Regarding the second question. Basically they want to clone the LUNs provisioned to the VG8 (where the NFS FS reside) and present that into a media server (networker)

I've got a another situation.... My project needs a lot of storage capacity and we cannot accomodate that in the exisitng VMAX frame. We are planning to provide a small/initial capacity of NFS shares to the project for them to start the build while we wait for the new Datamover to be installed in the exisitng VG8 frame. the new datamover will be connected to a new VMAX frame with lots of capacity.

Question is

When the new DM is installed and configured, what are the steps required to migrate the small/initial NFS share that was created to the project from the old DM to the new DM? then expand the filesystem as per project requirements.

mheloy wrote: .. Question is When the new DM is installed and configured, what are the steps required to migrate the small/initial NFS share that was created to the project from the old DM to the new DM? then expand the filesystem as per project requirements.

If the small/initial NFS share is a whole filesystem, then IP-Replicator could be used.

If it is only part of a FS, then maybe server_archive or a host based copy tool like rsnyc

mheloy wrote: Hi Rainer, Thanks for responding. Regarding the second question. Basically they want to clone the LUNs provisioned to the VG8 (where the NFS FS reside) and present that into a media server (networker)

I do not think, cloning  VG8 Luns and presenting them to a media server will give you any benefit. I doubt the media server will be able to backup the data in a useful way, because it does not know about the volume allocation on the luns.

Yes, the product is called SnapSure and it is included in the Local Protection Suite. It works at the filesystem level.

-- Adam Fox

Advisory SE, Emerging Technology Division

adam.fox@emc.com // 919-606-0911

Thanks Adam... I'll look for that... right now I just found a document

Using TimeFinder®/FS, NearCopy, and FarCopy on VNX

Is it the same?

Thanks Peter for helping out.

Another question... is there a snapshot functionality with VG8? like take a snapshot of a FS or NFS share then mount it as a different NFS share or someting similar?

mheloy wrote: .. Using TimeFinder®/FS, NearCopy, and FarCopy on VNX ..

this is dependent on what you want to achieve.

The mentioned product (TimeFinder) is creating 1:1 physical copies on special Symmetrix volumes (BCVs).

Take a look at page 9 of the manual.

Snapsure is creating Snaps (aka checkpoints) of a FS (logical copies), see page 21ff of the mentioned manual.

No. SnapSure runs on the DataMovers and works on filesystems. Those sound like block level products.

-- Adam Fox

Advisory SE, Emerging Technology Division

adam.fox@emc.com // 919-606-0911