Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
UNSOLVED
Adding DAE AX4-5
Hi,
I will be adding a DAE to an AX4-5. Went through the documentation and it says to connect SPA side first and then the B side. This differs from a CX in which you connect the B side first followed by the A side. Just wanted to confirm that it is different on the AX. Or if it even matters which side gets connected first? Also, can you use the NST for this procedure?
Thanks,
Dan
DanPhelan
7 Posts
547
0
Posted December 7th, 2009 08:00
Thanks for the clarification, Steve! Much appreciated! That also answered another question I had about the flare code upgrade. The array I am upgrading is running Navisphere Express. I prefer to use the NST since it provides more detail of the process, however someone told me that the NST was not supported for the AX series. However, I did not believe it since it is referenced in the documentation generated on the AX support site.
Thanks, again!
Dan