Solved!
Go to Solutionchanging fault disk, checking it with SPcollect, Report output
I changed a faulted disk in a CX4 240 following USM instructions normally it's working (no red light anymore) but when I checked the report and the SPcollect it seems that something is still wrong .
SP collect output :
Raid Drive Cur Max
Disk Group Capacity Intfc Vendor Drive Type Serial Number Part Number TLA Number Firmware State Replacing Speed Speed
1.2.14 20 600GB FC HITACHI LXWWAVHL DG118032690 005049694 C3A8 Enabled 1_3_4 4 4
1.3.4 27 600GB FC HITACHI Viper-C J9XGEKHL 118032690 005049033 C3A8 Equalizing -- 4 4
Report output Genarl-Issue :
| Severity | Component | Issue | Action |
Critical |
Hot spare 1_2_14 is in use. | Replace failed disk or call your service provider. |
Critical |
No host paths for the storage group Storage Group - Cluster POC. | Check host attachments. |
What does the second critical message means ??!!
Thank you in advance.
brettesinclair
2 Intern
•
715 Posts
1677
1
Posted February 17th, 2015 01:00
Has it finished equalizing (copying back to the replaced disk ) ?
You can check the status using naviseccli;
naviseccli -h arraysp getdisk 1_3_4 -state -rb
(scope and creds may be required)
Or from Unisphere by going into the Transitioning LUN properties and checking the "Percent Rebuilt" value.
Are there any active alerts/errors on the array?
brettesinclair
2 Intern
•
715 Posts
1677
0
Posted February 17th, 2015 02:00
Cool. ..and sorry, I missed the second question.
You may have a Storage Group (Cluster POC) with either no hosts or host with failed paths. With that name maybe it's left over from a project, but do check the Hosts Tab in the Storage Group properties.
s_15
7 Posts
1677
0
Posted February 17th, 2015 01:00
I agree that the rebuild ist not finished yet. For the second Event it seems that one or more Host in the Storagegroup "Cluster POC" got an connection Issue. So you should check the Initiatorstate and in addition check the connection on host side itself.
Regards