Solved!
Go to SolutionP
prawinready
15 Posts
0
3116
February 3rd, 2010 08:00
san copy Initiators
I am doing san copy migrations from cx 300 to cx 400, did zoning part correctly. Due to problem in creating san copy connections , I did deregister and when i want to register again I don't see those Initiators in cx 300 connectivity status. Zoning is Intact. how do i see these Initiators again in Connectivity status of CX 300 ?
Any suggestions please.
Thanks
Regards
Prawinready
prawinready
15 Posts
834
0
Posted February 3rd, 2010 08:00
Yes, I did that, No change.Do you have SanCopy installed on CX400 ?
This e-mail message (including any attachments) is for the sole use of
the intended recipient(s) and may contain confidential and privileged
information. If the reader of this message is not the intended
recipient, you are hereby notified that any dissemination, distribution
or copying of this message (including any attachments) is strictly
prohibited.
If you have received this message in error, please contact
the sender by reply e-mail message and destroy all copies of the
original message (including attachments).
prawinready
15 Posts
834
0
Posted February 3rd, 2010 08:00
Yes Sancopy is installed on cx4, created san copy sesssions for sp A luns and valiadated connections .I did deregister sp B Initiators in connectivity status, want to register but they dont showup in Connectivity status now .
The luns I want to migrate are of SP B,(Source and destination.)
Did you try SAN Copy > Update connections
This e-mail message (including any attachments) is for the sole use of
the intended recipient(s) and may contain confidential and privileged
information. If the reader of this message is not the intended
recipient, you are hereby notified that any dissemination, distribution
or copying of this message (including any attachments) is strictly
prohibited.
If you have received this message in error, please contact
the sender by reply e-mail message and destroy all copies of the
original message (including attachments).
prawinready
15 Posts
833
0
Posted February 3rd, 2010 09:00
I did that, Still i dont see, the Initiators of sp B.Try to drop zones between the two arrays and add them back, after that SanCopy > update connections
This e-mail message (including any attachments) is for the sole use of
the intended recipient(s) and may contain confidential and privileged
information. If the reader of this message is not the intended
recipient, you are hereby notified that any dissemination, distribution
or copying of this message (including any attachments) is strictly
prohibited.
If you have received this message in error, please contact
the sender by reply e-mail message and destroy all copies of the
original message (including attachments).
prawinready
15 Posts
833
0
Posted February 3rd, 2010 10:00
I did check that button.
dynamox
11 Legend
•
20419 Posts
•
87439 Points
1076
0
Posted February 3rd, 2010 19:00
take a look at this thread, make sure you specify correct WWN when you define source and target LUNs
https://community.emc.com/message/412323#412323