Thanks for ur response Sebastian.But as I shown in prev disucussion am not able to find the ips the array is taking and those ips which were in the screnn shot were those when box was configured early long back.

so you got the SPA and SPB address? Just connect to them and http://ip-spb/setup http://ip-spa/setup

and change it from here

But those are the ips , which were configured statically during first time deployment in different subnet(10.94.171.) .Now its being deployed in different subnet(10.94.171).Please find the screen shot which shows the inactive mgmt ip fields.So what should I do to change the ip SPA and SPB ips.

.

sure i know. try to connect to http://10.94.174.42/setup and http://10.94.174.43/setup --> login there --> try to change from here

Am not able to connect sir .This is wat I get whwn I tried to connect .Both storage array and initialization host are on same subnet

are you able to ping the 2 IPs

Hi

if you plugged in the LAN cable the right way ( MANAGEMENT PORT ) you should be able to ping. Anyway you still can try use the Service LAN Port.

https://community.emc.com/message/730239

Please try this ( connect ONLY to on SP NOT BOTH the same time ) afterwards try to ping the Service IP of the corresponding SP

So what is the next solution ?

From: N, Prashanth Kumar - Dell Team

Sent: Thursday, September 4, 2014 6:36 PM

To: 'jive-1898201892-b6tv-2-hx0d@emc-ecn.hosted.jivesoftware.com'

Subject: RE: - uninitialiase cx4 120c storage array

No sir they are the ips which are stored cached when they were connected to previous subnet and am not able to ping those ips .How to check which ips they have taken in new subnet they have connected.

No sir they are the ips which are stored cached when they were connected to previous subnet and am not able to ping those ips .How to check which ips they have taken in new subnet they have connected.