UNSOLVED

jvega1

updated

13 years ago

J

jvega1

25 Posts

0

969

June 27th, 2013 23:00

SyncIQ replication throughput low

I setup a replication job from Prod to DR site.  Replication throughput is low.  I have network rule set at 300 Mb/s but only getting 50Mb/s. 25MB on two nodes and third node seems to be idle. I've created another policy a week ago and the data replicated fine.  I was even able to throttle the network between 100, 200, 300, 500 mb/s and watch all 3 nodes work perfectly.

Any idea what may be causing this issue?

  • dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    642

    0

    Posted June 28th, 2013 04:00

    file operation per/sec rules in place ?

  • cincystorage

    2 Intern

    •

    467 Posts

    642

    0

    Posted June 28th, 2013 04:00

    Is it going across an low speed interface which is already overused?  One of the nodes 1gb connections, perhaps?  We had that happen when we moved SmartConnect from static ip assignment to dynamic..We had 4 10gb interfaces and a single 1gb interface in the zone... we limited connections to only the 10gb via dns... and specific interfaces in SyncIQ...  but when we enabled dynamic ip assignment,  we lost the ability to use specific interfaces... and it picked the 1gb connection on our ndmp accelerator...

  • jvega1

    25 Posts

    642

    0

    Posted June 28th, 2013 05:00

    i just checked this morning and all is back to normal.  We are getting 300 Mb/s between the 3 nodes.  Maybe our link between sites was saturated.  Thanks for the suggestions.