UNSOLVED

woolychaser

updated

19 years ago

0

3066

November 28th, 2007 22:00

Problems POSTing

I'm working on my in-law's Dimension 4700.  She said she had it off during a lightning storm and she hasn't been able to get it to boot.  I took a look and the power LED flashes yellow slow and steadily and I can't get it to do anything.  The power LED on the MB is on.  I replaced the PSU with no change so I swapped the old one back in.  I replaced the MB today just to be on the safe side and same problem.
 
I've removed the RAM, no change.  Looking at another post I powered the machine off, unplugged it, then held the power button in for 15 seconds and have removed the CMOS battery and am leaving that out for 15 mins.  Reseated the peripheral cards and the jumpers.
 
Anything else I can check?
  • 190

    0

    Posted November 28th, 2007 23:00

    Just an update:
     
    Replaced the CMOS battery and tried, but still just the blinking amber LED.  Removed all of the expansion cards, disconnected everything but the SATA drive and same thing.
  • green_jello

    1 Rookie

    •

    13 Posts

    190

    0

    Posted November 29th, 2007 02:00

    Next thing I would try is a different hard drive that has an OS allready installed. Sounds like you've eliminated all other possibilities.

    good luck.
  • tr4

    1 Rookie

    •

    1727 Posts

    190

    0

    Posted November 29th, 2007 02:00

    Power supply ,motherboard, ram, cpu. You already replaced the first three. Since nothing is happening, you do not have a hard drive or windows problem.
  • mombodog

    2 Intern

    •

    12735 Posts

    190

    0

    Posted November 29th, 2007 03:00

    Disconnect/Remove everything from the motherboard except the PSU connector. Yes I mean everything that can be removed. Processor, memory, cards, fans ect...
     
    If the light is still amber blinking, you have a toasted mobo.
     
    If it turns green, power down and add one component at a time , check the status light each time, do this until you find the bad component that causes the amber blinking.
  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    190

    0

    Posted November 29th, 2007 03:00

    If there's a surge protector or power strip connected between the PC and the outlet, remove it and plug PC directly into the wall. See if it'll boot that way before you strip the motherboard as mombodog suggested. ;)

    Ron
  • rawk

    32 Posts

    190

    0

    Posted November 29th, 2007 17:00

    Check for fried modem ,remove the modem and check it again
    had u already tried that .
     
    if the led on the Mb is green then Power supply is good and if it amber then there is power supply
     
    and if there are no beeps when memory is removed i am sure its a damaged processor .
     
     
    Processor replacement should do the trick
  • RoHe

    12 Elder

    •

    45230 Posts

    •

    172625 Points

    190

    0

    Posted November 29th, 2007 23:00

    A green LED on the motherboard only means that the board is getting power and not that the power supply is putting out the correct voltages. If the power button on the tower is amber/blinking then it still can be either a power supply issue or a problem with the power connection to the Pentium, so be sure to check that cable at both ends.

    Ron
  • 190

    0

    Posted November 30th, 2007 23:00

    Thanks for all the responses.  I will give these a try hopefully tomorrow when I stop by the house again.  I'll keep y'all posted.