UNSOLVED
Networker Auto eject media
Hi All,
Networker 7.3.2 on Windows 2003:
I have to set at view -> Diagnostic mark -> Properties on jukebox -> select advance and choosse Auto Eject feature but it can not work after backup finish.
How I do setting, If I want to eject media after backup finish?.
Thank
Suwan
Networker 7.3.2 on Windows 2003:
I have to set at view -> Diagnostic mark -> Properties on jukebox -> select advance and choosse Auto Eject feature but it can not work after backup finish.
How I do setting, If I want to eject media after backup finish?.
Thank
Suwan
- Small add-on to what dk has said - that will only work with:
- DDS devices
- shared libraries
- AS libraries
- silos
Certain work has been done to 7.3.x where part of LCP (from AS world) has ended up in NW code so I have seen this "sometimes" working under NW, but it still remains officially supported (designed to work) only for those listed above (nsr_jukebox manual).
dk3
163 Posts
221
1
Posted February 11th, 2007 05:00
please check Properties on jukebox -> Timers tab in Diagnostic mode. The value in field "Idle device timeout" may be the answer to your question. The number of minutes you enter here is used by Networker to unmount a tape after a specific time.Attention: 0 means no auto-eject. The Field help may give you further explanations here. The same field can be found under device configuration properties in Advanced tab. With this option a per device setting is possible.