I have a 6024F that I've added a new VLAN. I have connected this new vlan to the top level switch of an existing VLAN that I'm trying to migrate from (171). The new vlan is 40. I'm not sure what I need to do to get the routing on the new vlan to work. If I assign a static IP on the 40 subnet, I can't ping the router, but the 171 still works fine. Here are the relevant entries. I've also tried trunk mode on the ports also. Thanks. interface range ethernet g(19,21,23) switchport mode general exit vlan database vlan 10,20,30,40,50,171,175 exit interface range ethernet g(1,3,5) switchport access vlan 10 exit interface range ethernet g(2,4,6) switchport access vlan 20 exit interface range ethernet g(7,9,11) switchport access vlan 30 exit interface range ethernet g(19,21,23) switchport general allowed vlan add 40 exit interface range ethernet g(13,15,17) switchport access vlan 171 exit interface range ethernet g(19,21,23) switchport general allowed vlan add 171 exit interface range ethernet g(14,16,18) switchport access vlan 175 exit interface vlan 10 name BOWL exit interface vlan 20 name WS exit interface vlan 30 name CJ-LAB exit interface vlan 40 name PC exit interface vlan 50 name MFG exit interface vlan 171 name PCNET exit interface vlan 175 name OLD-MFG exit interface vlan 10 ip address 10.10.0.9 255.255.0.0 exit interface vlan 20 ip address 10.20.0.9 255.255.0.0 exit interface vlan 30 ip address 10.30.0.9 255.255.0.0 exit interface vlan 40 ip address 10.40.0.9 255.255.0.0 exit interface vlan 50 ip address 10.50.0.9 255.255.0.0 exit interface vlan 171 ip address 10.177.171.9 255.255.255.0 exit interface vlan 175 ip address 10.177.175.9 255.255.255.0 exit