I just installed 3 PC 6224's in a stack configuration. Now when I look at the port configuration it shows some of the ports running at half duplex and some running at full duplex and others it shows as being down.
Is there something I am missing? What other information is needed to get me going at full speed?
What is connected to these ports? Some printers (Especialy older ones) work at half duplex, also, some people will force their port speed on servers and workstations. All ports should be set to AUTO on both the switch and workstations.
You can try changing the advertisements, I would not force the port speed though unless you also force it on the client workstation or else you will do more bad than good. Be sure to check the charts on the switch for etherlike failures, etc.
If it is GB Ethernet connections never force the port speed as you will have issues, just change the advertisements to only advertise 1GB FD.
bdearlove
65 Posts
449
0
Posted July 14th, 2011 12:00
What is connected to these ports? Some printers (Especialy older ones) work at half duplex, also, some people will force their port speed on servers and workstations. All ports should be set to AUTO on both the switch and workstations.