I have hooked all the cables according to the diagrams, and still it cannot find the router. I plugged the ethernet cable from the modem to the router and then the router to the computer. Putting it in the ethernet slot in the computer. Any pearls of wisdom?
1) Between the cable modem and 2300 router, you should be plugged into the "WAN" port on the router(the isolated port)
2) You should have a cable plugged-in to port 1,2,3 OR 4 and the other end going to the ethernet card on your computer
3) Your computer should be setup for "DHCP" and not a "static IP" - what operating system are you running?
- if you have everything physically plugged in, you should at least have a connection to the router: try typing in http://192.168.2.1 to see if you can get to the setup page. username & password are both "admin"
On the 2300, the WAN port is called the Internet port. After connecting the 2300 to your cable modem, power the cable modem off, wait a minute, repower it and let it connect to your ISP, then try the 2300 again.
And..that software which comes with the tm 2300 router has a bug, hence, it is better to OT RUN it on any of the systems, because it might not find the internet connection / the router. We can configure the router depending on the ISP, manually, without running the CD.
jplee3
3 Posts
111
0
Posted June 18th, 2004 02:00
2) You should have a cable plugged-in to port 1,2,3 OR 4 and the other end going to the ethernet card on your computer
3) Your computer should be setup for "DHCP" and not a "static IP" - what operating system are you running?
- if you have everything physically plugged in, you should at least have a connection to the router: try typing in http://192.168.2.1 to see if you can get to the setup page. username & password are both "admin"
- let us know what the progress is!