UNSOLVED

snowcreekfam

updated

17 years ago

S

snowcreekfam

1 Message

0

3613

June 18th, 2009 07:00

carrier jam

I've been haing this problem lately, whenever I try to turn on my Dell All in One printer 944 the ink cartridges carrier slams from one side to the other. I've done everything that I have read about, but to no avail. Any suggestion?? 

  • llynster

    2 Intern

    •

    1700 Posts

    322

    0

    Posted June 18th, 2009 12:00

    I usually don't get involved in any of the ink model problems, but I know from personal experience the encoder strip that runs behind the carriage assy can be knocked out of place..... accidently..... and will cause the carriage head to beat itself against the inner walls of the printer.

    The encoder strip is a very delicate piece of plastic stretched from one side wall to the other side wall inside the printer. This strip has finely etched lines that provide positioning information to a "reader" on the back of the carriage assy. It's supposed to be positioned so that as the carriage moves, the plastic strip provides signals to the "reader". If the "reader" can't read the strip..... wham..... wham.

    Good luck!

  • PudgyOne

    11 Legend

    •

    30315 Posts

    •

    106638 Points

    322

    0

    Posted June 18th, 2009 13:00

    snowcreekfam,

     

    In addition to what "the Llynster" said, here are instructions on the encoder strip.

     

     

    Rick

     

    Edited to correct spelling, AGAIN!

    Clean the Encoder Strip

    Additional Information
    Notice:  
      As you perform the following steps, be careful when handling the encoder strip as it can break easily.  

    It is possible that dust can gather on the encoder strip which will make it very difficult for the printer to determine where the carriage is on its track. To clean the encoder strip, perform the following steps:

    1. Power down the printer and unplug the power.
    2. Lift the cover on the printer.
    3. Using a dry, lint free cloth, pinch the encoder strip on the right-hand side of the cartridge carriage and pull your fingers across it toward the right-hand side of the printer (Figure 1).


      Figure 1: The Encoder Strip to the right of the cartridge carrier

      Note:  
        The encoder strip is a narrow band of clear plastic and can be difficult to see without direct lighting.  
    4. Plug in the printer and power it on.
    5. Open the cover to allow the cartridge carriage to center itself.
    6. Using a dry, lint free cloth, pinch the encoder strip on the left-hand side of the cartridge carriage and pull your fingers across it towards the left-hand side of the printer. (Figure 2).


      Figure 2: The encoder strip to the left of the cartridge carrier