UNSOLVED
Closed
Error code: 2000-0415
Welcome,
a T130 (Debian) server did not start after the installation
by our electrical service provider
and has been flashing orange on the front and back since then.
The hardware test shows error message ePSA4239.45 Code: 2000-0415.
I moved cables, reset BIOS, checked button battery.
The fault ticket exists even without HDDs.
Where should I look for the error?
489
0
Posted April 3rd, 2023 11:00
Hello GBotond,
The images did not show up.
If they are large try resizing.
Could you make it a .jpg file?
See if you have given it a thorough flea power drain and check results.
If you still have an issue try clearing NVRAM.
Make sure you have the side on so it is not tripping the case open amber led.
1.drain flea power (shut down, disconnect power cables and Network cables, hold in power button 20 seconds with cords removed). After flea power drain, system has to set for 3 minutes for DRAC to reset without any power plugged in, then plug in NIC and power but wait 2 minutes before power on to give DRAC time to initialize.
2.Clear NVRAM - there is a map under the lid to show the jumper location. Shut down, Set jumper to the Clear position, power on and Post up to the jumper error, shut down and return jumper to original location.
DELL-Charles R
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Accept as Solution’. ‘Thumbs up’ the posts you like!519
0
Posted April 2nd, 2023 21:00
Hello thanks for choosing Dell. How about we run Mimimum to Post:
The minimum components to allow the Dell™ PowerEdge™ T130 to complete POST are as follows:
- System board
- CPU with heat sink
- Single DIMM configuration with DIMM in socket A1
- Control panel with cable (to power system on)
- Power supply unit
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!507
0
Posted April 3rd, 2023 00:00
Thank you for your answer,
I started with this and unfortunately the cable error still exists.498
0
Posted April 3rd, 2023 06:00
Hi,
please provide the exact error message and which cable is shown as affected.
Regards Martin
with kind regards Martin/ Liebe Grüße Martin
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
DELL-Martin S
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
491
0
Posted April 3rd, 2023 11:00
Hi, I have attached 2 error messages from Lifecycle Controller Hardware Diagnostics.
Thank you
Botond488
0
Posted April 3rd, 2023 11:00
462
0
Posted April 4th, 2023 03:00
Hi,
the door was open, luckily that was all there was to it after I wiped everything down.
I didn't think that would be a problem.
Thank you all for your help!Regards
Botond
DELL-Charles R
Moderator
•
4730 Posts
•
25476 Points
487
0
Posted April 3rd, 2023 11:00
Hello GBotond,
Thank you I received the images.
The last word on the top line is Intrusion.
Check that the intrusion switch is properly installed and connected
Intrusion Switch Page 48 : https://dell.to/430DWKp
DELL-Charles R
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Accept as Solution’. ‘Thumbs up’ the posts you like!